Quickly and practically tests the starting and charging system voltage and shows the results. It is used to check the battery level. With its integrated printer, it is possible to obtain the results as a hardcopy. Also tests the batteries under 1 volt. It meets with the specifications of multiple evaluation systems (SAE, DIN, EN, IEC). It has reverse polarity protection.
Tests multiple battery material structures including standard (water-covered) and AGM. Suitable for CCA batteries from 200 to 900. Tests the 12-Volt battery and electrical system for cars and vans.
Midtronics diagnostic equipments are used by world-wide vehicle manufacturers and professionals.
Before starting to test the battery, please check the battery and be sure that there is no scratches, leakages, cracks on the surface. If you see any of the above mentioned errors please immediately change the battery. If the Electrolyte level is below the average please fill the battery with pure water and charge it to full.
Battery Tester Device notifies you if the surface charge is detected, in this stiuation please open headlights, ventilator or other tools which consume electricity to get rid out of the surface charge. This will help you test the battery accurately.
When tested right after the battery charge, results may deceive. Please wait for 8-12 hours after battary charge for the most accurate results.
Some conditions require tester to know wether the battery is in pre-Charge or post-Charge condition. Please choose the right object.
Türkçe
English
